Move pointer over the image to zoom in

feeler gauge

feeler gauge is a tool used to measure gap widths. Feeler gauges are mostly used in engineering to measure the clearance between two parts.[1]

They consist of a number of small lengths of steel of different thicknesses with measurements marked on each piece. They are flexible enough that, even if they are all on the same hinge, several can be stacked together to gauge intermediate values. It is common to have two sets forimperial units (typically measured in thousandths of an inch) and metric (typically measured in hundredths of a millimetre) measurements.

A similar device with wires of specific diameter instead of flat blades is used to set the gap in spark plugs to the correct size; this is done by increasing or decreasing the gap until the gauge of the correct size just fits inside the gap.[2]

The lengths of steel are sometimes called leaves or blades, although they have no sharp edge.

Write Review

Note: HTML is not translated!

Powered by Abantecart eCommerce Solution